Proxmox VE Initial Configuration

Proxmox VE 9.2

Proxmox Virtual Environment

Proxmox VE Downloads

Proxmox VE Administration Guide

Before You Start

These notes cover initial configuration after installing Proxmox VE 9.2. Run the host commands from the Proxmox shell or an SSH session as root.

The examples use pve-01 as the node name and 192.168.2.4 as its management address. Replace both with the values configured during installation.

Access the Web Interface

From another computer on the same network, open the management address on HTTPS port 8006:

Proxmox Web Interface

Sign in using the installation credentials:

Field Value
Username root
Realm Linux PAM standard authentication (pam)
Password Root password configured during installation

A browser certificate warning may appear because Proxmox initially uses a self-signed HTTPS certificate. Confirm that you are connecting to the intended host before proceeding.

Connect over SSH

Connect to the Proxmox host:

ssh root@192.168.2.4

Inspect the hostname, network configuration, storage devices, and memory:

hostnamectl
ip -br addr
ip route
lsblk
free -h

Configure Package Repositories

A fresh installation may have enterprise repositories enabled. These require a valid Proxmox subscription; without one, apt update may report an authentication error:

401 Unauthorized

Disable Enterprise Repositories

For a host without a subscription, open the repository settings in the web interface:

pve-01 > Updates > Repositories

Select each enabled enterprise entry and click Disable:

  • Proxmox VE Enterprise.
  • Ceph Enterprise, if present.

Keep the Debian base, updates, and security repositories enabled.

Enable the No-Subscription Repository

On the same page, select Add > No-Subscription to enable the Proxmox VE repository.

Proxmox VE 9.2 uses Debian Trixie. The equivalent traditional APT source entry is shown below as a reference:

deb http://download.proxmox.com/debian/pve trixie pve-no-subscription

Only one active entry for this repository is needed. If it is already configured through the web interface, do not add a duplicate entry manually.

The no-subscription repository is intended for testing and non-production use. Proxmox recommends the enterprise repository for production. See the repository documentation.

If the host uses Ceph, configure its repository separately for the installed Ceph release. Adding the Proxmox VE no-subscription repository does not configure Ceph package updates.

Update the Host

From the Proxmox host shell, refresh package metadata:

apt update

Resolve repository errors before upgrading. Then run the full upgrade and review the proposed changes before confirming:

apt full-upgrade

Reboot when required, especially after a kernel update. Shut down or migrate running guests before restarting the host:

reboot

Verify the Installed Version

Reconnect after the reboot and display the Proxmox package versions:

pveversion -v

The setup notes recorded an update to version 9.2.21. Use the pveversion -v output to identify the actual installed package versions; this recorded value is not a required upgrade target.

Licensed under CC BY-NC-SA 4.0
Last updated on Wednesday, October 14, 2026
comments powered by Disqus